ANON Factory higher good quality sweet corn harvester mix Corn Silage Round Baler
ANON Manufacturing unit high quality sweet corn harvester merge Corn Silage Spherical Baler
1. Eco-friendly fodder harvesting baler, 1 piece of tools, can sell the crops into professional feeds in the field on the very same working day, conserving the expense of intermediate transportation and crushing, and the large-density wrapping technologies can get to 500 kg.It can not only make certain the refreshing characteristics and very good quality of silage, but also improve function effectiveness and earnings.
2. The CZPT crushing technique is equipped with a drum variety CZPT breaker. The hole of the CZPT crushing roller is adjustable, and the CZPT breakage charge is in excess of 95%.
three, robust feeding and shredding capacity, one bundle effectiveness breaks via 1 minute, the highest sum of perform for each hour can get to thirty tons.
4, CZPT automatic lubrication method, the operation of the bearing and other key parts immediately oil lubrication, properly minimizing servicing time.
five, two-phase feeding system, four-roller linkage sort to improve the feeding roller, can engage in the position of flattening, ending, tiling, feeding crops, ready for subsequent cutting.
six, improve the knife roll, the chopping component is enhanced, the CZPT to chop the crop is increased, the herringbone cutter is organized, the crop is squeezed and shredded at the very same time, when compared to the a single-line sliding cut far more uniform, no repetition, cutter electrical power Minimal loss
7. Fortify the keep track of chassis, the grounding region is massive, the grounding stress is tiny, the force is mild, and the turning radius is tiny. The earth can keep large-pace procedure quick, and little plots these kinds of as muddy paddy fields can wander and flip freely.
The lubricating oil exterior circulation products of the worm gear reducer equipment has low oil temperature. The worm equipment reducer plans to traverse its energy. The worm gear is manufactured of non-ferrous metal. Master info worms are usually created of difficult metal. Therefore, using a lot of heat in the software, coupled with the impact of the ambient temperature, it is hard to control the temperature of the reducer. Use within the temperature variety. When the ambient temperature is reduced than 0℃, the doing work temperature of the worm equipment reducer must be controlled at -40℃~40℃. It is suggested to heat or use a minimal freezing point lubricant just before the oil is fully dissolved.